Install The Enclosure - Bosch Easy Series ICP-EZM2 Quick Start Manual

4 en | Install the Enclosure
1

Install the Enclosure

Refer to Figure 1.1 for the suggested placement of system components in the enclosure.
Notice!
Use proper anchor and screw sets when installing the enclosure on non-load-bearing
surfaces, such as drywall.
Follow anti-static procedures when handling the control panel board. Touch the earth ground
terminal on the control panel board to discharge any static charge before working on the
control panel board.
If you install more than one control center, mount them at least 1.2 m apart.
Do not install the RADION receiver within 15 cm (6 in) of the control centers metal enclosure.
3
Figure 1.1: System component placement in enclosure
2014.09 | 01 | F.01U.306.216
6
5
4
12 VDC
Quick Start Guide
7
Easy Series Control Panel
1
2
Bosch Security Systems, Inc.