Configure The System; Configuring With The Telephone; Configuring With Rps - Bosch Easy Series ICP-EZM2 Quick Start Manual

8 en | Configure the System
3

Configure the System

Configure the system using one of the methods described in this section for your control
panel type.
3.1

Configuring with the telephone

Refer to Installer Telephone Menu, page 12 for the complete programming menu.
Basic Programming:
1.
2.
3.
4.
5.
6.
If the point number is not currently assigned to a Wireless ID:
To set Point Type, press [1].
To add a device, press [2].
Press [#] to exit.
If the point number is currently assigned to a Wireless ID:
To set Point Type press [1].
To replace a device, press [3]
To delete this device, press [4].
Press [#] to exit.
1.
2.
3.
4.
3.2

Configuring with RPS

In addition to the Installer Phone Menu, you may use RPS to configure an Easy Series control
panel with RADION support. To configure RADION wireless points, specify the following
information for each point:
–
–
–
–
Since Wireless Alarm Inputs is only available in "Expert Mode", you must use Expert Mode to
properly configure the Easy Series control panel for RADION wireless devices.
The following table shows the correlation between the current RPS Device Type values and
the RADION Device Types.
1.
2014.09 | 01 | F.01U.306.216
Enter the Installer passcode (default: 4-digit 5432, 6-digit 543211).
Press [3] to enter the Basic Programming menu to make the following changes:
– Modify point types [1][2].
– Record point descriptions [1][1].
– Enter an account number [2][1].
Press [#][#][#] to exit Basic Programming.
Press [1] to enter System Maintenance to configure wireless devices.
Select Wireless Configuration [6] from the System Maintenance menu.
After the system prompt, enter the point number (1 to 32) that you want to configure.
The control panel announces the point number and the point type.
Press [#][#] to exit to the main menu.
Press [2] to enter the User Menu to change the installer passcode.
Press [1] and change the Installer Passcode.
Press [#][#] to exit the User Menu.
Device Type
Point Type
Wireless Point ID
Wireless Alarm Inputs
Once the device type has been selected in RPS, enter the Wireless Point ID and Point
Type via the "wizard" dialog.
Quick Start Guide
Easy Series Control Panel
Bosch Security Systems, Inc.