Call Channel Programming; Display Backlighting; Voice Scrambler Function - Icom IC-M59euro Instruction Manual

Call channel programming

The call channel key, [C], is used to select the call channel
which you can program your most often-used channels.
Push [C] to select the call
channel.
• "CALL" and the call channel num-
ber appear.
While pushing [HI/LO] push
[C] to enter call channel write
mode.
• Call channel number flashes.
Rotate the channel selector to
select the desired channel.
Push [C] again to program the
displayed channel as the call
channel.
• The call channel number stop
flashing.
NOTE: For U.K./Italy versions, a call channel is available
separately for each channel group (INT, USA). Select the
desired channel group in advance.
The function display and switches can be backlit for better vis-
ibility under low light conditions.
While pushing [
TAG
CALL
just the backlighting.
INT
Backlighting can be set to 1 of 3 intensities or turned OFF.
CALL
INT
CALL
INT
Some countries prohibit the use of voice scrambled communi-
cations. An optional UT-79
CALL
sary to use this function.
INT
While pushing [HI/LO], push [DIAL] to toggle the function
ON and OFF.
• "SCRM" appears when the function is
ON.
• This function cannot be used on
channel 16.
• Set the scramble code in SET mode in advance (p. 19).
BASIC OPERATION

Display backlighting

•DIM], rotate the channel selector to ad-
HI/LO

Voice scrambler function

VOICE SCRAMBLER UNIT
3
is neces-
SCRM
USA
11