Safety Warnings - Cisco 860 Series Hardware Installation Manual

Safety Warnings

The illustrations in this chapter show a wireless router with antennas attached. Non-wireless routers do
Note
not have antennas or antenna connectors on the back panel. However, the procedures for connecting
devices to the router are the same for both wireless and non-wireless routers.
Note Depending on the features available for your router, some content in this chapter may not apply to your
router.

Safety Warnings

Warning When installing the product, please use the provided or designated connection cables/power
cables/AC adaptors/batteries. Using any other cables/adaptors could cause a malfunction or a fire.
Electrical Appliance and Material Safety Law prohibits the use of UL-certified cables (that have the
"UL" or "CSA" shown on the cord), not regulated with the subject law by showing "PSE" on the cord,
for any other electrical devices than products designated by CISCO. Statement 371
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
This equipment has been designed for connection to TN and IT power systems. Statement 1007
Warning
There is the danger of explosion if the battery is replaced incorrectly. Replace the battery only with
Warning
the same or equivalent type recommended by the manufacturer. Dispose of used batteries according
to the manufacturer's instructions. Statement 1015
Take care when connecting units to the supply circuit so that wiring is not overloaded. Statement 1018
Warning
Warning To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement 1021
Warning Hazardous network voltages are present in WAN ports regardless of whether power to the unit is OFF
or ON. To avoid electric shock, use caution when working near WAN ports. When detaching cables,
detach the end away from the unit first. Statement 1026
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide
3-2
Chapter 3 Connecting the Router
OL-16215-10