Chapter 2 Installing The Router - Cisco 860 Series Hardware Installation Manual

Installing the Router
This chapter describes the equipment and the procedures for successfully installing the Cisco 860 series,
880 series, and 890 series Integrated Services Routers (ISRs), and contains the following sections:
Equipment, Tools, and Connections, page 2-2
•
Installing the Router, page 2-3
•
Note For compliance and safety information, see the Regulatory Compliance and Safety Information
Roadmap that ships with the router and the
Series and SOHO Series Routers.
All wireless LAN products in the 5.2/5.3GHz band cannot be used outdoors. Use the product only
Warning
indoors. Statement 372
Warning Read the installation instructions before connecting the system to the power source. Statement 1004
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
Warning
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, because they may cause serious injury or death. For
proper installation and grounding of the antenna, please refer to national and local codes (for
example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code,
Section 54). Statement 1052
No user-serviceable parts inside. Do not open. Statement 1073
Warning
Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide
OL-16215-10
C H A P T E R
Regulatory Compliance and Safety Information for Cisco 800
2
2-1