Equipment Connection; European Union Radio Equipment And Telecommunications Terminal Equipment (R&Tte) Directive (1999/5/Ec) And En 301 489-1; European Union Electromagnetic Compatibility (Emc) Directive (2004/108/Ec) - Comtech EF Data CRS-170A Installation And Operation Manual

CRS-170A L-Band 1:1 Redundancy Switch
Preface

Equipment Connection

THE CRS-170A IS DESIGNED FOR OPERATION ONLY WITH THE COMTECH EF DATA
PRODUCTS LISTED IN THIS MANUAL UNDER 'RELATED DOCUMENTS'. THESE
PRODUCTS SUPPLY DC OPERATING CURRENT (ELECTRONICALLY FUSED AND
PROTECTED) AND CONTROL SIGNALS FOR THE CORRECT FUNCTIONING OF THIS
SWITCH. CONNECTION TO OTHER MANUFACTURERS' EQUIPMENT COULD RESULT
IN DAMAGE TO THE SWITCH. THE CRS-170A IS NOT COMPATIBLE WITH OTHER
COMTECH EF DATA MODEMS OR PRODUCTS NOT LISTED IN THIS MANUAL.
European Union Radio Equipment and Telecommunications Terminal
Equipment (R&TTE) Directive (1999/5/EC) and EN 301 489-1
Independent testing verifies that the unit complies with the European Union R&TTE Directive, its
reference to EN 301 489-1 (Electromagnetic compatibility and Radio spectrum Matters [ERM];
ElectroMagnetic Compatibility [EMC] standard for radio equipment and services, Part 1:
Common technical requirements), and the Declarations of Conformity for the applicable
directives, standards, and practices that follow:
European Union Electromagnetic Compatibility (EMC) Directive
(2004/108/EC)
•
Emissions: EN 55022 Class B – Limits and Methods of Measurement of Radio Interference
Characteristics of Information Technology Equipment.
•
Immunity: EN 55024 – Information Technology Equipment: Immunity Characteristics, Limits,
and Methods of Measurement.
•
EN 61000-3-2 – Harmonic Currents Emission
• EN 61000-3-3 – Voltage Fluctuations and Flicker.
•
Federal Communications Commission Federal Code of Regulation FCC Part 15, Subpart B.
TO ENSURE THAT THE UNIT COMPLIES WITH THESE STANDARDS, OBEY THESE
INSTRUCTIONS:
•
Use coaxial cable that is of good quality (e.g., RG58/U (50Ω) or RG59/U (75Ω)) for
connections to the IF Tx and Rx (transmit and receive) BNC female connectors.
•
Use Type 'D' connectors that have back-shells with continuous metallic shielding.
Type 'D' cabling must have a continuous outer shield (either foil or braid, or both). The
shield must be bonded to the back-shell.
xiv
Revision 10
MN/CRS170A.IOM