Assembling Fuel Bed And Commissioning; Assembling The Ceramics And Fuel Bed (Coal Variants) - Flavel Windsor Installation, Maintenance & User Instructions

ASSEMBLING FUEL BED AND COMMISSIONING

3.1 ASSEMBLING THE CERAMICS AND FUEL BED - COAL MODELS
a) Place the fuelbed base centrally on to the fuelbed support and push
fully backwards to the rear face of the fibre boards Make sure that the
fuelbed base is located centrally in the fire box, behind the
retaining tabs as shown below in figure 12.
Fig. 12
b) Position the front row of four large loose coals along behind the first
row of coals, ensuring that the flame paths as indicated are not
interupted. See figure 13 below.
Fig. 13
SECTION 3
Position fuel-bed base behind
retaining tabs
18