Operating The Fire (Electronic Fire Control Models) - Flavel Windsor Installation, Maintenance & User Instructions

5.3 LIGHTING THE FIRE - ELECTRONIC FIRE CONTROL MODELS
a) The control comprises an electronic fire control (EFC) trim switch to
ignite the fire and adjust the gas flow. The electronic fire control trim
switch is located at the top right hand side of the fire. To light the fire
proceed as follows:-
To light the fire using the electronic fire control (trim switch), press the
ignition button as indicated below in figure 1. The fire will emit a
"beep" sound, the button can now be released. After a few seconds an
audible clicking can be heard and then the fire will light the pilot and
then light the main burner. The ignition cycle will take approximately 20
seconds. It is recommended that for the most efficient performance the
fire is allowed to warm up for a few minutes with the input set to high.
b) To reduce the level of heat input on the fire, press the small flame
button on the trim switch. (An audible beep will be heard)
c) To increase the level of heat input on the fire, press the large flame
button on the trim switch. (An audible beep will be heard)
d) To leave the fire in the standby mode (pilot only running) press the small
round button on the trim switch. (An audible beep will be heard).The
fire should not be left in the standby mode when unattended.
e) To switch the appliance off completely, press the Ignition / Off button on
the trim switch, the fire will then switch off. (An audible beep will be heard)
Fig. 1
Ignition / Off Button
Standby Button
Large Flame Button
Small Flame Button
35