2.1
UNPACKING THE FIRE
Carefully lift the fire out of the carton. Remove the loose item packaging carefully
from the front of the appliance. Check the contents as listed :-
Packing check list - manual control models
1 off
Fire box / burner assembly
1 off
Boxed ceramic base and 7 synthetic coals
1 off
Loose items bag inc guarantee card and cable fixing kit
1 off
Installation / user book (combined)
1 off
Efficiency baffle
1 off
Pebble set (if ordered as an optional extra) pack 2 of 2
1 off
Trim / Fret or Fascia (as applicable)
Packing check list - electronic fire control models
1 off
Fire box / burner assembly
1 off
Boxed ceramic base and 7 synthetic coals
1 off
Loose items bag inc guarantee card, battery holder & cable fixing kit
1 off
Installation / user book (combined)
6 off
1.5V batteries
1 off
Efficiency baffle
1 off
Trim / Fret or Fascia (as applicable)
1 off
Pebble set (if ordered as an optional extra) pack 2 of 2
2.2
INSTALLING THE FIRE BOX
Establish which type of flue you are intending to install the fire in to :-
225 x 225mm (9 inch x 9 inch) brick built chimneys
175mm (7 inch) diameter lined brick or stone flue, insulated pre-fabricated
metal flue box to BS 715 / BS EN 1856-2 or Pre-Cast Flue to BS EN 1858
When installing into 125mm (5 inch) diameter lined brick or stone flue, or
insulated pre-fabricated metal flue box to B.S. 715 and pre-cast flues the
restrictor baffle must not be fitted.
A spillage test must always be carried out to check satisfactory
clearance of flue products, regardless of the type of flue the
appliance is being fitted to.
SECTION 2
INSTALLATION OF FIRE
11