Replacing Warmer Drawer Element & Thermo Disc - Electrolux EW30GF65G Series Product & Training Manual

Replacing Warmer Drawer element & thermo Disc
The warmer drawer element and thermo disc are
Photo A
mounted to a metal base pan which must be removed
side shield screws
in order to replace the element or thermo disc. From
the rear of the range remove the screws that secure the
warmer drawer base and the warmer drawer side shields
to the main back panel. (Photo A)
Remove the warmer drawer as described on the
previous page.
element Base Pan screw
Disconnect the wire harness plug connector for the
Photo B
warmer element. (Photo B)
Remove the ¼" hex screws that secure the drawer
guide rail and element base pan on each side of the
drawer opening. (Photo C)
Remove the drawer guide rail and drawer shield together
Warmer Element
by pulling straight forward.
Harness Plug
Once both of the drawer guide rails and side shields have
been removed the base pan and element assembly can
Guide Rail Screw
be pulled forward to remove from the range. (Photo D)
Drawer Guide Rail
With the element and base pan assembly removed
the element and thermo disc are accessible for
servicing. (Photo E)
Drawer Side Shield
To remove the element from the pan remove the
screws and clips that secure it to the pan. Also remove
the screw that secures the thermo disc mounting
Photo C
Base Pan Screw
bracket.
When reinstalling the thermo disc mounting
bracket always insure that the element terminal
shield is installed and properly positioned.
Photo D
Pull Forward
Photo E
Mounting Screws and Clips
Thermo Disc Mounting Bracket
Page 48