Bake Burner And Ignitor - Wave Touch Models - Electrolux EW30GF65G Series Product & Training Manual

To remove and replace the bake burner begin by
disconnecting the bake burner ignitor harness.
The harness is accessed by removing the access
cover plate that the power cord and strain relief are
attached to at the rear of the range. The cover plate
is located to the right of the safety valve when viewed
from behind the range. (Photo A)
Take out the cover plate mounting screw and remove
the cover. The power chord can be disconnected
from the harness connector and placed aside with
the cover plate.
Once the cover plate is removed the ignitor harness
connector can be disconnected from the harness
connector on the right side of the opening. (Photo B)
Unplug the lower oven temp probe connector to aid
in accessing the ignitor harness connector. (Photo C)
The wiring connections for the oven gas safety valve
are also accessed through this opening and the
opening around the safety valve (Photo D)

Bake Burner and Ignitor - Wave Touch Models

Safety Valve
Bake Burner Ignitor
Harness Connector
Lower Oven Temp Probe
Harness Connector
Bake Burner Ignitor
Harness Connector
Bake Burner Safety
Valve Terminals
Page 40
Cover Plate
Photo A
Mounting Screw
Photo B
Power Cord
Harness Connector
Photo C
Photo D
Broil Burner Safety
Valve Terminals