Cooktop Removal - Wave Touch Models - Electrolux EW30GF65G Series Product & Training Manual

To remove the cooktop for service first
remove the grates and burner caps as seen
in photo A.
Lift the right front burner off the cooktop and
place it aside. The remaining burners are
secured to the top with a single screw in each
burner. (Photo B). Use a #1 square drive bit
to remove these mounting screws at each
burner orifice assembly.
Lift off the four remaining burners and place
them aside.
The burner orifice holder assemblies are
secured to the top by one screw in each
assembly with the exception of the right front
orifice holder which has four screws.
(Photo C)
Use a #1 square drive bit to remove these
mounting screws at each orifice holder
assembly.
When reinstalling the burner caps on Wave Touch model gas ranges you must align the grooves on
the underside of the cap with the vanes on the burner. (Photo D)
The cap can must be
properly aligned in order to
be fully seated. (Photo E)
The right front dual burner
and cap do not have
alignment vanes or slots.

Cooktop Removal - Wave Touch Models

Alignment
Grooves
Page 29
Left Front
Photo D
Alignment
Vanes
Photo C
Right Front
Photo E
Photo A
Photo B