Lower Oven Components - Iq Touch Models; Warmer Oven Theory Of Operation - Iq Touch Models; Removing And Replacing Warmer Drawer - Electrolux EW30GF65G Series Product & Training Manual

Wave-touch and iq touch freestanding gas ranges

Hide thumbs

Table Of Contents

Table of Contents

WARMER OVEN THEORy OF OPERATION - IQ TOUCH MODELS

Warmer drawer operation is controlled by the EOC and Oven Relay board. When the warmer drawer

is first activated a thermal disk mounted in the drawer cavity is used to detect when the warmer

drawer is cold and a call for heat is needed.

If the thermal disk is initially closed, the EOC assumes that the warmer drawer is cold. In this case the

Warmer Drawer relay activates and the heating element provides continuous heat (100% time ON)

until the thermal disk opens.

After the thermal disk opens the control starts cycling the warmer drawer relay based on timing data

that is programmed into the EOC. The cycle timings correspond to the warmer drawer settings and

are typically as follows:

WD Settings

Relay Timing

50 sec OFF

The thermal disk status is monitored during all the time while the Warmer Drawer is active. If the

status changes to "closed", the relay activates again and the heating element provides continuous

heat until the thermal disk opens.

To Remove the Warming Drawer:

1. Turn power off before removing the Warmer Drawer.

2. Open the drawer to the fully opened position (Photo C)

3. Remove the retaining screw in the right glide release

lever.

4. Pull up on the left glide lever and push down on the

right glide lever.

5. Pull the drawer away from the range.

To Replace the Warming Drawer:

1. Pull the bearing glides to the front of the chassis

glide (See Photo D).

2. Align the glide on each side of the drawer with the glide

slots on the range.

3. Push the drawer into the range until levers "click"

(approximately 2"). Pull the drawer open again to seat

bearing glides into position. If you do not hear the levers

"click" or the bearing glides do not feel seated remove the

drawer and repeat steps 1-3. This will minimize possible

damage to the bearing glides.

4. Reinstall the retaining screw in the right glide lever