Orifice Holders - Electrolux EW30GF65G Series Product & Training Manual

orifice holders

THE PROCEDURE FOR SERVICING ORIFICE HOLDERS IS THE SAME FOR WAVE TOUCH AND IQ TOUCH
MODELS
Once the cooktop has been removed the
Photo A
individual orifice holder assemblies are
accessible for service. (Photo A)
Orifice Holder
Assemblies
Each orifice holder assembly is connected to
the burner valve by a compression fitting on
the end of the gas supply line. (Photo B)
The supply line is part of the orifice holder
assembly. Use care when removing and
installing the compression fitting onto the
burner valve.
Photo B
When disconnecting the ignitor wire from
Photo C
the ceramic ignitor on the orifice holder you
must depress the locking tab in order for the
terminal connector to release.
Depress Tab
To Release
Page 32