Replacing Oven Door Light Switch; Servicing Oven Burners And Components; Convection Fan Blade Cover; Removing Oven Bottom - Electrolux 30” GAS FREESTANDING RANGES Service Update Manual

Replacing Oven Door Light Switch

The oven door light switch is mounted to the front
of the oven chassis near the top left corner of
the door opening. To access the door switch the
cooktop and burner box must be removed.
Carefully disconnect the wires to the switch and
compress the spring locking clips that secure the
switch to the frame. The switch can now be pulled
forward from the mounting hole.

SERVICING OVEN BURNERS AND COMPONENTS

The bake and broil burners, convection fan blade and cover, oven bottom and interior oven lights are
accessible for service from the front of the range.

Convection Fan Blade Cover

To access the convection fan blade remove the
two screws that secure the convection fan blade
cover and remove the cover.

Removing Oven Bottom

With the fan blade cover removed take out the
two screws at the rear of the oven bottom panel.
Lift the rear of the oven bottom up approximately
3 inches and slide the panel toward the rear of the
range to disengage the front edge from the slot in
the front frame.
Lift the front edge of the panel above the edge
of the front frame and remove the oven bottom
panel .
Fan Blade Cover
Screws
Oven Bottom Screws
Page 24
P/N 316439221