Table of Contents
Advertisement
Metal and Porcelain Liner Panel Installation Guide
1. Remove the glass door, grate bar assembly, and firebox baffle. Remove the screws from the lamp plate
and lay it on top of the burner with wires connected. Also remove the left and right filler pieces from the
burner pan (See fig.1 below).
2. Tilt the bottom of the Rear Panel backward and position it against the back firebox wall behind the burner
pan. Push the Rear Panel back against the firebox. This panel is secured by the Side Panel once they are
installed.
3. Remove the two middle screws from the bottom of the cavity access panels (See fig.2 below), as well as
the brick clips in the upper front of the firebox. Tilt the side panels into the firebox. Begin with top front
corner of side panel inside firebox. Ensure the side panels are positioned firmly against the back panel
and against the side of the firebox wall. Replace brick clips and screws.
4. Reinstall the baffle using its original screws. NOTE: When reinstalling the baffle, ensure that the integrity
of the firebox is not compromised. The firebox must remain airtight. Use high-temperature Millpac to
reseal if necessary.
5. Replace the left and right filler pieces and the lamp plate on the burner pan. Reinstall the grate bar
assembly.
6. To remove Liners, simply reverse these steps.
Parts List
Part No.
3927ML, 4634ML
3927PL, 4634PL
Note: Warping and
Discoloration of Porcelain or
Painted Metal Liners Is Not
Covered Under Warranty.
Both Porcelain and Painted
Metal Liners may discolor and
warp during normal operation of
your appliance. This is normal,
and not considered a defect.
: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
Warning
approved with this appliance may result in property damage or personal injury.
Description
Metal Liner Kit
Porcelain Liner Kit
fig.1
Contents
1ea. Rear Panel
1ea. Left Side Panel
1ea. Right Side Panel
2ea. Access Panel Black
fig.2
17
Hide quick links:
Advertisement
Table of Contents
