Framing Your Gas Fireplace - Marquis Cove MQZDV3927N Installation Instructions Manual

NOTE: The diagrams shown are only intended to illustrate dimensions. They are not to be used as advice for
construction practices. Please have the appliance framed and installed by a qualified installer adhering to local
building codes and practices.
Choose a fireplace location and frame it in accordance with the framing dimensions as illustrated in Figure 4 and Figure 5.
Bend the four [4] nailing tabs on the side of the appliance forward 90 degrees. Make note that the distance between the front
face of the fireplace and the nailing tab is approximately 1/2" [1.27cm]. This implies that 1/2" facing material is required to
ensure that the unit is flush with the wall.
When installing this fireplace against a non-insulated exterior wall or chase, it is recommended that the outer walls be
insulated to conform to applicable insulation codes. Drywall must be installed over insulation material to prevent direct
contact with the appliance.
MQZDV3927
For Propane Horizontal installations the venting must be a minimum of two feet vertical off

Framing your Gas Fireplace

Cold Climate Recommendation
55-1/2"Min
the flue before going horizontal.
MQZDV4634
68-1/2"Min
Figure 4 - Side view of framing guide.
10