Show Content - Polycom RealPresence Immersive Studio User Manual

Show Content

You can show content from a computer that is connected to your RealPresence Immersive Studio system.
Connect the computer by using the HDMI or VGA cables located in the table. The cables extend out of the
pocket as you gently pull them. Recoil the cables gently using the recoil button.
Note: RealPresence Immersive Studio 21-Seat system connections
For the RealPresence Immersive Studio 21-Seat system, connections are located in the front table
only.
For best video quality, use refresh rates of 60 Hz or less. Set the resolution and refresh rates according to
your computer's instructions.
Before you show content, test the PC you are using and check that the computer video output is configured
to use one of the supported resolutions and refresh rates shown in the following table.
Supported Resolutions and Refresh Rates
Resolution
800 x 600
1024 x 768
1280 x 720
1280 x 768
1280 x 1024
1600 x 1200
1680 x 1050
1920 x 1080
1920 x 1200
To show content:
1 Choose one of the following:
 Out of a call, tap
Polycom, Inc.
Refresh Rates (Hz)
56, 60, 72, 75, 85
60, 70, 75, 85
50, 60
60
60, 75, 85
60
60
60
60
.
15