System Maintenance - Polycom RealPresence Immersive Studio User Manual

System Maintenance

Clean your system regularly to ensure proper functionality. Use the following table for detailed cleaning
information.
Recommended Cleaning Procedures
Component Recommended Cleaning Procedure
Front wall panels To remove general soiling and water stains on the laminate surface of
and table top the front and back table tops, use a damp cloth. If needed, use a
surfaces hard-surface, all purpose cleaner such as Formula 409
Top Job, Mr. Clean, etc., and follow the manufacturer's instructions. To
prevent staining, ink should be removed as soon as possible. Do not
use paint thinners, naphtha, or solvent-based fluids. Always rinse and
wipe the laminate surfaces dry after cleaning.
Camera cluster Do not clean the camera cluster, which is centrally located in front of
the media wall within a camera housing.
Camera cluster Using a soft sponge, a wool cloth, or chamois, wipe the polycarbonate
enclosure and shield with lukewarm water containing a neutral detergent, such as
shield Formula 409, Windex, or Joy
polycarbonate shield. Do not leave cleaners on for a long period, or
apply cleaners in direct sunlight or at elevated temperatures. Be sure
to rinse off cleaners with lukewarm water. Never use razor blades,
scrapers, squeegees, or brushes.
Carpet For carpeting, vacuum daily using a vacuum cleaner with a cylinder
brush. Treat spots and spills as soon as they occur. Always try to
remove the spot with water before using a spotting solution.
When vacuuming, be careful not to bump into the media wall. Doing so
may mis-align the camera, resulting in compromised video.
Ceiling Micro- Gently dust with a feather duster as needed.
phone Arrays
Polycom, Inc.
® . Be very careful not to scratch the
® ®
, Fantastik ,
18