IMPORTANT
The network board for this printer cannot be connected to networks other than those
•
listed above.
Make sure that there is a port available on the hub to which the printer will be connected.
•
An additional hub must be installed if there is no free port.
NOTE
When connecting to the 100BASE-TX Ethernet network, all the devices to be connected
to LAN, such as hub, LAN cable, and network board for computer, must support
100BASE-TX. For more details, contact your local authorized Canon dealer.
1
If you are using NB-C1, attach the ferrite core to the LAN cable
as shown in the figure.
Attach the ferrite core at 5 cm or less from the end of the connector which is
connected to the printer.
5 cm or less
Connecting to a Computer
1
1-17