Canon Laser Shot LPB3500 User Manual page 373

CAUTION
Be sure to turn the printer OFF, unplug the power plug, and then disconnect all
•
the interface cables and power cord from the printer before installing the
network board. If a USB cable is connected, turn the computer off, and then
remove the USB cable. If you attempt to install the network board when the
printer is ON or any cable is connected to the printer, this may result in an
electrical shock.
Be careful when handling the network board. Touching the edges or a sharp
•
portion of the network board may result in personal injury.
IMPORTANT
The network board contains components that are sensitive to static electricity. Observe
the following precautions when handling the network board to prevent damage from
static electricity.
- Touch a metal object to dissipate static electricity before handling the network board.
- When handling the network board, do not touch anything that generates static
- Do not touch the network board parts, printed wire, or connectors with your hands.
- To prevent the network board from being affected by static electricity, keep it in the
6
NOTE
This network board does not come with a LAN cable. A Category 5 twisted pair cable is
required for installing the network board and connecting the printer to a network. Have
cables or a hub ready as needed.
6-32 Network Board
electricity such as the computer display.
protective bag until it is ready to be installed. The protective bag is required after the
network board is removed. Keep the protective bag and do not discard of it.