Resetting The Network Board - Canon Laser Shot LPB3500 User Manual

The ERR indicator on the network board is on.
Cause The network cable is disconnected or broken, or the network board is not
installed properly.
Remedy 1 Make sure the network cable is connected properly.
Remedy 2 Replace the network cable with a proper one and check if there is no
disconnection or damage.
Remedy 3 If the ERR indicator still comes on even after applying the Remedy 1 and 2,
contact your local authorized Canon dealer for servicing.
The ERR indicator on the network board blinks at an interval of four times.
Cause The DIP switch 1 on the network board is ON.
Remedy Set the DIP switch 1 to OFF once.
The ERR indicator on the network board keeps blinking.
Cause The hardware of the network board is in an abnormal condition.
Remedy Contact your local authorized Canon dealer for servicing.

Resetting the Network Board

If you want to reset the network board to the default values, use the Remote UI or
FTP Client. For details on the Remote UI, see "Chapter 3 Various Functions of
Remote UI" in Remote UI Guide, and on FTP Client, see "Chapter 5 Appendix" in
Network Guide.
Even if none of the above procedures work, you can reset the settings for the
network board by manipulating the DIP switches using the following procedure. A
Phillips screwdriver is required to reset the settings for the network board. Have a
screwdriver ready in advance that matches the size of the screws.
1
Turn the printer and computer OFF, remove the USB cable,
and then disconnect the power plug from the AC power outlet.
2
Remove all the interface cables and the power cord from the
printer.
Network Board 6-43
6