Operation Instructions - Titan SF1500XP Safety And Operating Manual

Fig 1
Fig 2
Fig 3
Fig 4

OPERATION INSTRUCTIONS

WARNING! Before using this tool, make
sure you read the instructions carefully.
Operating the router.
Note: Make sure to disconnect the router from
mains supply before fixing any accessories.
Your router comes with the depth stop bar not
assembled. Be sure to fit the depth stop bar on
the machine before use.
1. FITTING AND ADJUSTING THE DEPTH
STOP BAR (see fig1)
(a) Loosen the fixing screw, insert the depth stop
bar into the hole of holder. (see fig1)
(b) Adjust the depth bar upward or downward,
note the position of the body on the scale and
raise the depth stop rod by the required amount.
Each mark on the scale is equal to 1mm.
(c) Tighten the depth stop bar fixing screw.
(d) If you want to make some accurate adjustment,
micro-adjustment can be made by turning the
micro depth adjustment knob. A full turn is equal
to 1mm.
2. FITTING THE VACUUM ADAPTOR (see
fig2)
For the sake of your health and working
environment, always use a vacuum adaptor.
Use the two long screws to fasten the adaptor
socket securely to the routing base.The adaptor
socket is suitable for vacuum adaptor with a
suction hose of 36mm diameter.
3. FITTING THE ROUTER BIT (see fig3 and
fig4)
To insert a router bit, proceed as follows:
(a) Press in the spindle lock button, loosen the
collet nut and insert the required router bit,make
sure the "k" marking (Maximum free shank
length line )is in the same line with the nut below
surface.Maximum free shank length of router bits
please reter to router data table.(see fig3)
(b) Press in the spindle lock and tighten the collet
nut. (see fig4)
4. ADJUSTING DEPTH OF CUT (see fig5, fig6
and fig7)
The depth of cut is the distance between the triple
depth stop and the depth stop bar.
Router bits vary in depth, the triple depth stop