SOLTEK SL-85DRV3 User Manual page 62

85DRV3
DRAM Clock/Drive Control
When this option is chosen, the following item appears for user's
configuration.
CMOS Setup Utility - Copyright (C) 1984-2001 Award Software
Current FSB Frequency
Current DRAM Frequency
DRAM Clock
DRAM Timing
SDRAM CAS Latency
Bank interleave
Precharge to Active(Trp)
Active to Precharge
Active to CMD(Trcd)
DRAM Burst Len
DRAM Command Rate
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
* Current FSB / DRAM
Frequency
* DRAM Clock The value represents the performance parameters
* DRAM Timing When this item Enabled, DRAM Timing is set by
* DRAM Command
DRAM Clock/Drive Control
This item is to show the current FSB / SDRAM
Frequency.
of the installed memory chips (DRAM). Do not
change the value from the factory setting unless you
install new memory that has a different performance
rating.
SPD.
SPD (Serial Presence Detect) is located on the
memory modules, BIOS reads information coded in
SPD during system boot up.
The choices: 1T Command; 2T Command.
Rate
62
Menu Level
By SPD
By SPD
2
Disabled
3T
6T
3T
4
2T Command
Item Help