Mercedes-Benz C-Class Operator's Manual page 386

Changing a wheel
384
To remove: take socket ; and lug wrench
X
= from the vehicle tool kit (
Position socket ; on hub cap :.
X
Attach lug wrench = to socket ; and
X
loosen hub cap : counter-clockwise.
Remove hub cap :.
X
To install: before installing, check hub
X
cap : and the wheel area for soiling and
clean if necessary.
Put hub cap : in position and turn until it is
X
in the right position.
Position socket ; on hub cap :.
X
Attach lug wrench = to socket ; and
X
tighten hub cap :.
The tightening torque must be
18 lb-ft (25 Nm).
i
Note that the hub cap should be tight-
ened to the specified torque of 18 lb-ft
(25 Nm). Mercedes-Benz recommends
that you have the hub cap installed at a
qualified specialist workshop.
Using a lug wrench =, loosen the bolts on
X
the wheel you wish to change by about one
full turn. Do not unscrew the bolts com-
pletely.
page 340).
Y
The jacking points are located just behind the
front wheel housings and just in front of the
rear wheel housings (arrows).
Vehicles with AMG equipment: the vehicle
has covers installed to protect the vehicle
body next to the jacking points on the outer
sills.
Vehicles with AMG equipment: fold
X
cover ? upwards.
Position jack B at jacking point A.
X