Automatic Car Wash - Mercedes-Benz C-Class Operator's Manual

Care
330
should drive for a few minutes after clean-
ing. Braking heats the brake discs and the
brake pads/linings, thus drying them. The
vehicle can then be parked.
Regular care of your vehicle is a condition for
retaining the quality in the long term.
Use care products and cleaning agents rec-
ommended and approved by Mercedes-Benz.
Washing the vehicle and cleaning the
paintwork

Automatic car wash

G WARNING
Braking efficiency is reduced after washing
the vehicle. There is a risk of an accident.
After the vehicle has been washed, brake
carefully while paying attention to the traffic
conditions until full braking power is restored.
! If DISTRONIC PLUS or the HOLD function
is activated, the vehicle brakes automati-
cally in certain situations. To prevent dam-
age to the vehicle, deactivate DISTRONIC
PLUS and the HOLD function in the follow-
ing or other similar situations:
when towing the vehicle
R
in the car wash
R
! Never clean your vehicle in a Touchless
Automatic Car Wash as these use special
cleaning agents. These cleaning agents can
damage the paintwork or plastic parts.
! Make sure that:
the side windows and the sliding sunroof
R
are fully closed.
the ventilation/heating is switched off
R
(the OFF button has been pressed).
the windshield wiper switch is at position
R
0.
the 360° camera or rear view camera is
R
switched off.
The vehicle may otherwise be damaged.
! If the SmartKey is within the rear detec-
tion range of KEYLESS-GO, the following
situations, for example, could lead to the
unintentional opening of the trunk:
using a car wash
R
using a power washer
R
Make sure that the SmartKey is at least
10 ft (3 m) away from the vehicle.
! Make sure that the automatic transmis-
sion is in neutral position N when washing
your vehicle in a tow-through car wash. The
vehicle may otherwise be damaged.
Operating with the SmartKey:
R
Do not remove the SmartKey from the
ignition lock. Do not open the driver's
door when the engine is switched off or
at very low speeds. Otherwise, when in
transmission position D or R the auto-
matic transmission will automatically
switch to park position P and block the
wheels.
Operating with the Start/Stop button:
R
Do not open the driver's door when the
engine is switched off or at very low
speeds. Otherwise, when in transmission
position D or R the automatic transmis-
sion will automatically switch to park
position P and block the wheels.
Observe the following to make sure that the
automatic transmission stays in position N
neutral:
Operating with the SmartKey:
Make sure that the ignition is switched on.
X
Make sure that the vehicle is stationary.
X
Depress and hold the brake pedal.
X
Shift to neutral N.
X
Release the brake pedal.
X
Release the electric parking brake, if nec-
X
essary.
Switch off the ignition and leave the Smart-
X
Key in the ignition lock.