Tektron ME901 Operation Manual page 72

8.2 Linear Rail Maintenance
Add lubricating oil to the rail daily. The details as below:
Turn off the power supply;
Add a few lubricating oil on a cotton fabric and move the print head to original position.
Brush the rail with the cotton fabric to create an average oil layer on the Rail;
Power the printer and move the print head unit left and right repeatedly；
Erase the oil smear on the both ends of the rail. Erase the oil drops on the rail again before printer running。
8.3 Print-head Maintenance
Always keep the print head surface wet with flush solution. If the printer is left unused, the print head must be
move to clean station and covered by capper ,to keep it wet and in a good condition..
If there would be two or more days not use the printer, please do follow procedure to keeping the nozzle of the
head be tried out.
Apply flush solution on the pad of head capper. Initial head capping procedure to park the head on clean
station.
If more than four days not using, disconnect the damper from the head, flush the head by using flush
solution. Initial capping procedure.
Unload print head
Do as follows when you are going to unload print head:
Suck the ink out from print head and clean it with flush solution by using injector；
Power off the printer and plug out power line from socket；
Check static on the machine with a multi-meter and release the static if necessary；
Loosen Right screws, and take out the right screw；
Take out the print head and put it on an unwoven fabric soaked with flush solution
Please wear the anti-static wrist strap when connect the print heads onto the print heads
driven board, otherwise will result in a damage to the print heads or print heads driven board.
8.4 Ink Supply Maintenance
Clean out the ink in all tubes and cartridges
Remove 8 cartridges from the printer, clean the remains out from the cartridge..
Check the rubber seal on the cartridge. Replace a new one if necessary.
Re-install the sensor and cap.
ME ME ME ME Series Series Printer Printer Operation Operation Manual
Series Series Printer Printer Operation Operation
- 71 -
Manual
Manual Manual