Tektron ME901 Operation Manual page 31

2.9.3 Move media edge guide to cover the media edge in both side.
2.9.4 Head Initializing and nozzle checking
Enter head cleaning procedure, choose Standard, press OK. The ink is being sucked into the head and
sucked out by vacuum. While the process completed, the display will back to Main Manu. Press Nozzle Check,
the carriage will move left and a nozzle status bar will be printed. Observe each nozzle status, and do clean
process again if necessary.
Note: if there still have some nozzles don't jetting well, please stop clean and do some printing for while, then
do the clean process again.
While all process is done, the machine is ready to run for further adjustment and calibration.
Please be noted that the first installation should be done by service engineer, or under the guide
of service engineer.
ME ME ME ME Series Series Printer Printer Operation Operation Manual
Series Series Printer Printer Operation Operation
- 30 -
Manual
Manual Manual
Observe the media edge is
under the middle of three
holes.