Tektron ME901 Operation Manual page 35

Capping
Wiper_Pos
Wiper_Cycle
Carriage_Spd
Param_Set
Vacuum_Adj
Auto_Purge
ME ME ME ME Series Series Printer Printer Operation Operation Manual
Series Series Printer Printer Operation Operation
Press Up key again to stop.
Press Exit key, the carriage will move to home position, the display back to
last Manu.
Do this clean procedure every week.
Lighten this item, press OK to confirm, the carriage moves right to capping
station. The capper will rise up to cover the head. Please observe the
rubber edge of copper touches the head surface well, there is no gap
between the surface and rubber edge.
It is must to do before switch off the printer. Otherwise the nozzle of head
would not be wet well and gets dried out and damaged.
Press Exit key, the carriage will move to home position and standby.
Lighten this item, press OK to confirm. The wiper will turn to working
position. Press Left or Right key to change to position of the wiper. The
number displayed indicates the angle of the wiper turned.
The position of the wiper has been set in the factory. This procedure is
done by service engineer while the wiper is worn out and change.
Lighten this item, press OK to confirm. The number displayed indicates the
times the wiper wipes the head after cleaning. Use Left or Right key to
change the number. The range is 1 to 3.
The default is" 1". Mean the wiper wipes one time after cleaning.
This procedure is done by service engineer only.
Lighten this item, press OK to confirm. Use Up or Down key to select the
speed mode.
Produ: the productivity is high but the image quality is little low
Fine: the productivity is little low but the image quality is better
Lighten this item, press OK to confirm. The vacuum fan starts run. Use Left
or Right key to change the vacuum strength on printing platen.
0 is Disable, there is no vacuum generated on the platen.
1~9 indicates the vacuum strength from weak to strong.
depending on the thickness of the media, in most case, thin material
requires weaker vacuum.
Press Exit key to stop the fan and back.
This is the function to keep nozzles wet by periodic jetting process while
printer is in standby.
Lighten this item, press OK to confirm. Use Left or Right key to change the
value. Larger number indicates more strong head purging.
- 34 -
Manual
Manual Manual
This value is