13.
Maintenance
Order Information
Only use iSys products to ensure the best quality and performance from your hardware. Using other products
may adversely affect your printer's performance and invalidate your warranty.
Item
Toner, black
Toner, Cyan
Toner, Yellow
Toner, Magenta
Image drum, black
Image drum, cyan
Image drum, Magenta
Image drum, yellow
Transfer Belt
Fuser (120V)
Fuser (230V)
*Based on continuous print.
Toner Cartridge Replacement
NOTE: When the LCD display indicates TONER LOW, or if print appears faded, first
open the top cover and try tapping the cartridge a few times to evenly distribute the
toner powder. This will enable you to obtain the best "yield" from your toner
cartridge.
CAUTION! To avoid toner wastage and possible toner sensor errors, do not change
the toner cartridge(s) until "TONER EMPTY" is displayed.
Have a sheet of paper handy so that you have somewhere to place the used cartridge while you install the new one.
Dispose of the old cartridge responsibly, inside the pack that the new one came in. Follow any regulations,
recommendations, etc., which may be in force concerning waste recycling. If you do spill any toner powder, lightly
brush it off. If this is not enough, use a cool, damp cloth to remove any residue. Do not use hot water, and never use
solvents of any kind. They will make stains permanent.
WARNING! If you inhale any toner or get it in your eyes, drink a little water or bathe
your eyes liberally in cold water. Seek medical attention immediately.
WARNING! If the printer has been powered on, the fuser may be hot. This area is
clearly labeled. Do not touch.
June 2011: Revision 002
Life
11,000 Letter @ 5%
11,500 Letter @ 5%
11,500 Letter @ 5 %
11,500 Letter @ 5%
30,000 Letter pages *
30,000 Letter pages *
30,000 Letter pages *
30,000 Letter pages *
60,000 Letter pages *
60,000 Letter pages *
60,000 Letter pages *
ELITE II ORDER NO.
600-1360
600-1362
600-1366
600-1364
600-1370
600-1372
600-1374
600-1376
600-1380
600-1381
600-1382
35
Need help?
Do you have a question about the iTerra Elite ll and is the answer not in the manual?