10 Options; Options General View - GE Digital Energy LP 33 Operating Manual

g
10.1

OPTIONS GENERAL VIEW

Mains Input
Load
Fig. 10.1-1 RPA Parallel System
Fig. 10.1-2 Additional battery cabinet
Fig. 10.1-3 Customer Interface
Fig. 10.1-4 SNMP Card
Fig. 10.1-5 Connectivity Software
OPM_LPS_33E_10K_30K_4CN_V010.doc

10 OPTIONS

RPA kit
Redundant Parallel Architecture
Allows to extend the unit to a parallel system with 2, 3, or 4 units
connected on the same bus, which ensure the highest reliability rate and
increase the power availability without prior investments.
Battery Extension Packs
Extended run-time versions are equipped with additional batteries housed
in the UPS itself, to increase the back-up time of the UPS when the mains
fails.
Additional battery cabinets
Depending on model the battery extensions can be housed in additional
cabinets with the same design of the UPS cabinet, delivered with the
necessary protection and connection material.
For extended run-time versions and additional cabinets see enclosed Data
Sheets.
Additional battery charge
For battery with extended backup time (max. 8.2 A).
Customer Interface
The Customer Interface allows the client the exchange of information
(monitoring and control) with the following interfaces:
•
Serial port RS232.
•
6 programmable output channels.
•
2 programmable input channels, of witch one for GEN-ON.
•
EPO (Emergency Power Off).
SNMP Card
Simple Network Management Protocol
The SNMP Card is an Interface to the Ethernet Network, and provides
UPS information via the standard SNMP protocol.
The UPS can therefore be managed by a Network Management System
(NMS) or by our applications (for instance JUMP), which uses this
information to determine the state of the UPS in order to guarantee safe
and orderly shutdown of the server, when needed.
Connectivity Software
ARGUS / PowerFlag / JUMP, IRIS Service, etc.
74/82
Operating Manual LP 33 / 10-20-30 kVA
GE