Interconnections; Ey 500 Rear Interconnection Panel - Simrad EY500 Instruction Manual

System familiarization

1.2.6 Interconnections

Figure 3 shows the rear panel of the EY 500 transceiver. It has the following
connectors:
* COMPUTER (25-pin D-conn. male) for connection to the standard parallel
input on the PC. The cable should be less than 1 m and is a 1/1 connection.
* PRINTER (25-pin D-conn female) for connection to the printer input. The
printer cable is a standard Centronics cable and should be max. 5 m.
* TRANSDUCER (12-pin Amphenol military standard type connector,
female) for single and split beam transducer.
* AUXILIARY (15-pin D-conn female) for output of +5 V, ±20 V. Ground, TX
output, 2xfrequency output and power shutdown input control.
* POWER (Cannon connector, male) for 10 - 40 VDC.
* Ground screw.
The PC must have the following ports:
TRANSDUCER
(CD474)
Figure 3 EY 500 rear interconnection panel.
* Centronics port for connection to the EY 500 transceiver
* Serial port for input of navigation data/or remote control and output
telegrams.
8
(Ground)
COMPUTER AUXILIARY
25 pin male 15 pin female
OFF
POWER
10 - 40 V Dc
PRINTER
25 pin female
ON
P3400/B