Changing The Paper Type In A Tray - Sharp AR-6020 Operation Manual

BEFORE USING THE MACHINE
Metric (AB series) and inch series reference
Inch series (inch)
5-1/2" x 8-1/2" (Invoice)
8-1/2" x 11" (Letter)
8-1/2" x 13" (Foolscap)
8-1/2" x 13-2/5"
8-1/2" x 13-1/2"
8-1/2" x 14" (Legal)
11" x 17" (Ledger)
4
Change the selected tray's paper size.
\
See "LOADING PAPER" (p.39)
Easy setting mode (Only the bypass tray)
If you are using the bypass tray, you can be easily set the paper size in the easy setting mode.
• You can not set the paper type at the moment.
Note
• If the paper size is EXTRA, numerical can not be registered.
1
Use the [TRAY] key to select the
bypass tray.

CHANGING THE PAPER TYPE IN A TRAY

When you change the type of paper used in a tray, always follow the procedure below to change the paper setting of
the tray.
• The paper type cannot be set when operation is paused due to running out of paper or a paper misfeed, or
Note
during interrupt copy. The paper type cannot be set during printing.
• Change the paper type setting in copy mode. The setting cannot be changed while copying is being executed or
in scanner mode.
• Do not load a type of paper that is different from the tray setting. This may cause paper misfeeds.
42
Metric series
(AB series) (mm)
140 x 216
216 x 279
216 x 330
216 x 340
216 x 353
216 x 355
279 x 432
The bypass tray indicator
will light.
5
Press the [START] key (
the [PAPER] key.
The paper size indicator sheet of the size set
Note
in step 3 appears in the window on the right
side of the tray.
Important points when using the printer mode
Make sure that the tray's paper size setting is the
same as the tray's paper size setting in the printer
driver. For example, if the tray's paper size setting is
A4R (8-1/2" x 11"R), set "Set Paper Size" to "A4R"
("Letter-R"). For more information, see
"CONFIGURING THE PRINTER DRIVER"
2
Use the [SIZE] key to select the paper
size.
3
Press the [START] key (
Paper size for the bypass tray is confirmed.
) and then
To change the paper size
setting of another tray,
repeat steps 2 to 5 after
pressing the [START]
key ( ).
(p.23).
The bypass tray indicator
will blink.
).