LOADING PAPER
Make sure that the machine is not copying or printing, and then follow these steps to load paper.
Loading the paper tray
1
Gently pull out the paper tray until it
stops.
2
Push the pressure plate down until it
locks in place.
3
Extend the partition plates in the tray.
Partition (B)
Partition (A)
4
Load paper into the tray.
Push the centre of the
pressure plate down until
it locks into place.
• Open the package of
the paper and load it
without fanning the
paper.
• Make sure the stack of
paper is straight before
loading it.
BEFORE USING THE MACHINE
• Do not load paper higher than the line on
Note
the tray (up to 250 sheets (up to 500
sheets, when AR-6026N/AR-6031N is
used)).
• Do not add paper to the loaded paper.
It may cause multiple feed of paper.
5
Adjust the partition plates in the tray
to match the length and width of the
paper.
6
Gently push the paper tray into the
machine.
• If you loaded a different size of paper than
Note
was loaded previously in the tray, go to
"CHANGING A TRAY'S PAPER SIZE
SETTING"
(p.41).
• When misfeed occurs, rotate the paper
180 degrees and reload it.
• Straighten curled paper before using it.
2
39