Id Card Copy - Sharp AR-6020 Operation Manual

ID CARD COPY

You can copy the front and back sides of ID card onto a page through this function. The specified patterns of ID card
copy are shown as follows.
Pattern 1
Front
Back
• Select the layout patterns as explained in
Note
below to perform the copy. For changing a system setting, refer to
SETTING" (p.94).
• ID card copy feature cannot be used in combination with interrupt copy, two-sided copy, dual page copy,
XY-zoom, margin shift, edge + centre erase, 2 in 1/4 in 1, sort/group and rotation copy functions.
• The following paper sizes can be used:
Pattern 1: A4 (8-1/2''x11'') is recommended.
Pattern 2: A5 to A3 ((5-1/2''x8-1/2'' to 11"x17"). (A5 (5-1/2''x8-1/2'') can only be used in bypass tray.)
• When using Pattern 1, the image may cut off even if using standard paper size.
• In ID card mode, refer to "CUSTOMISING SETTING (system settings)"(page 86), if you want to set the number
of copies. Scan area is: X: 98mm, Y: 66mm.
• Auto paper selection and auto tray switch are invalid in ID card copy mode. Please select paper and tray
manually.
• The ID card should be placed 5mm from the original size scale in order that the image will not be cut off when
copying.
• For ID card copy, enlargement ratios can be selected. However, depending on the paper size, copy image may
be an omission.
1
Press the [ID CARD COPY] key.
2
Place the ID card on the document
glass, align with the ID card mark, and
press the [START] key (
When scanning, ORIGINAL DATA
indicator will blink after scan is finished,
ORIGINAL DATA indicator will go off and one
side of the ID card is scanned into memory. (In
this case, print will start if pressing [READ-END]
key ( ).)
Centre Line
"ID card"
The ID CARD COPY
indicator will light up.
).
Pattern 2
of SYSTEM SETTINGS (p.93)
"SELECTING A SETTING FOR A SYSTEM
3
Turn the ID card to the other side, and
press the [START] key (
When scan finished, Copy will begin.
To cancel ID card copy, press the [CLEAR
Note
ALL] key ( ) and make sure the ID CARD
COPY indicator is off.
COPY FUNCTIONS
first, then follow the steps
).
65
3