Sharp AR-6020 Operation Manual page 46

COPY FUNCTIONS
Auto paper select mode (when there are two or more paper trays)
When the AUTO PAPER SELECT indicator lights up, "Auto paper select mode" is enabled. This function
automatically selects the paper that is the same size as the original A5, B5, B5R, A4, A4R, B4, A3 (5-1/2" x 8-1/2",
8-1/2" x 11", 8-1/2" x 11"R, 8-1/2" x 13", 8-1/2" x 13-1/2", 8-1/2" x 13-2/5", 8-1/2" x 14" and 11" x 17") paper. "Auto
paper select mode" can be disabled in the system settings.
• The sizes of paper that can be used vary by country and region.
• If a zoom setting is selected after placing the original, the paper size that is appropriate for the zoom setting will
be automatically selected.
• "Auto paper select mode" is cancelled if the automatic ratio selection is enabled
with the [PAPER] key. Auto paper select resumes operation when the [CLEAR ALL] key (
"Auto clear time" activates.
Removing the document cover
To copy large originals like newspapers, remove the
document cover. To remove it, open the document
cover and lift it at a slightly backward angle.
To replace the cover, do the reverse.
The RSPF cannot be removed.
Copying books or originals with folds or
creases
Press down on the document cover/RSPF while
copying as shown. If the document cover/RSPF is
not completely closed, shadows may appear on the
copy or it may be fuzzy. Straighten originals with
folds or creases well before placing.
46
(p.91)
(p.48)
Originals that can be used in the RSPF
Originals that are A5 to A3 (8-1/2" x 11R" to
11" x 17") and 50 g/m
lbs.)
(2-sided copying or scanning : 50 g/m
(15 lbs. to 28 lbs.)) can be used. A maximum of 100
pages can be placed at once.
Insert a number of originals that does not exceed
the indicator line on the document feeder tray.
• Make sure that there are no paper clips or
Note
staples on the original.
• Straighten curled originals before placing
them in the document feeder tray. Curled
original may cause misfeeds.
• When you set multiple sheets of thick
original, if the original is not fed, reduce
the number of the set originals.
Originals that cannot be used in the RSPF
The following originals cannot be used. These may
cause misfeeds or smudging and unclear images.
• Transparencies, tracing paper, other transparent or
translucent paper, and photographs.
• Carbon paper, thermal paper.
• Originals that are creased, folded, or torn.
• Glued originals, cut-out originals.
• Originals with binder holes.
• Originals printed using an ink ribbon (thermal
transfer printing), originals on thermal transfer
paper.
Stream feeding mode
If "Stream feeding mode" is enabled in the system
settings (p.91), the RSPF indicator will blink for
about 5 seconds after all originals are fed. If a new
original is placed in the RSPF during this time, the
original will be automatically fed in and copying will
begin.
or if a tray is selected
) is pressed or when
2 2
to 128 g/m (15 lbs. to 24
2
to 105 g/m
2