Table of Contents
Advertisement
Chapter 3: Using the Hardware
If your device locks up, you can reset the device by pressing
the Power button for 10 seconds or until the screen goes
dark. After a few seconds, the device turns on again.
Restoring the device to its factory state. Follow the steps
below to restore the user storage, settings, and icons on your
Field PC to their original factory defaults.
!
WARNING! Restoring the Field PC to its original factory
state will permanently erase data saved on the Field PC, any
software you installed, and any changes you made to the
Field PC, including settings changes.
1. Reset the device from the power button menu or by
holding down the power button until the display goes
dark.
2. When the green notifi cation LED light appears on the
front of the Field PC, simultaneously press and hold the
following buttons for several seconds:
Clean Boot: Home, up arrow, Context
Clean Storage: Task, up arrow, Return
Clean Registry: Start, Context
Clean All: Return, left arrow, Context
3. Hold the buttons until the progress bar reaches the
second tick mark and then disappears. Factory settings
are restored automatically.
Using the stylus
The stylus is stored in an open slot at the top of the device. A
hole in the stylus end allows you to attach a lanyard.
Like the left button on a desktop computer mouse, the stylus
is a tool that lets you select or deselect items and enter data.
•
K
two plac
ress bar
drawn. E
o
H
boot.
o
T
o
S
o
R
19
Advertisement
Table of Contents
