Alto-Shaam 6.10ESG Technical & Service Manual page 59

S E R V I C E M O D E A N D E R R O R C O D E S
TO EXIT THE SERVICE MODE
PRESS THE START KEY TO EXIT FROM THE SERVICE MODE TO THE NORMAL TIME DISPLAY.
MOST COMMONLY USED PARAMETERS
R-Numbers
R01 CTC-1 Multi-Point Product Probe
R02 CTC-2 Multi-Point Product Probe
R03 CTC-3 Multi-Point Product Probe
R04 CTC-4 Multi-Point Product Probe
R05 Oven Temp Sensor (N-6)
R06 Bypass Probe (B-5)
R07 Condensate Probe (B-3)
R08 Steam Generator (B-4)
R09 STB Probe (N-8 Immersion Safety Probe)
R10 PT-100 Single-Point Product Probe
R13 Electronic Temp (Control Temperature)
R20 Lower Level-Water Level Probe *
R21 Upper Level-Water Level Probe *
R23 Door Switch *
R29 Software BM (Display Board)
R30 Software SM (Relay Board)
R31 Software KM (HACCP Board)
R38 Errors (see R-Number instructions)
* For these parameters, [0] = Not Satisfied, [1] = Satisfied.
TO REBOOT THE CONTROL
Rebooting the control can sometimes fix an error code or a control that is frozen or confused:
PRESS AND HOLD THE ON/OFF POWER KEY FOR FIVE SECONDS.
The display will flash and show ST5000 for 20 seconds, followed by "Please Wait", and then will
return to the time and date.
PRESS THE ON/OFF POWER KEY MOMENTARILY.
The unit will turn on and can be operated normally.
S 3 – S
E C T I O N
M E
E R V I C E O D E A N D R R O R
C-Numbers
C01 Nom Standby Temp
C02 Nom Cond Temp
C03 Fan on Cycle
C04 Fan off Cycle
C05 Cont Steam
C06 Init
C07 Humidity S
C08 Humidity SS
C09 Humidity Quick
C10 Humidity Reg
C11 Humidity Reg g
C12 Bitfield 1
C13 Bitfield 2
C19 PIN
C23 Time Browning
C24 Door Venting
C • C O M B I T H E R M G A S T
O D E S
D-Numbers
D01 Delete Errors
D02 Key Lock
D03 Delete All Programs
D04 Self Test BM (Display Board)
D06 Red Fan Speed
D07 Fan
D08 Steam Gen 1
D09 Convection 1
D10 Steam Gen 2
D11 Convection 2
D12 Oven Lamp
D13 Cond Cooling
D14 Steam Gen Fill
D28 Venting Motor
D30 Smoking Element
D31 Solenoid Valve
S M
E C H N I C A L E R V I C E A N U A L
• 5 9