Service Mode Instructions - Alto-Shaam 6.10ESG Technical & Service Manual

S E R V I C E M O D E A N D E R R O R C O D E S
S E R V I C E M O D E I N S T R U C T I O N S
The service mode is accessible on units with Standard or Deluxe controls only.
TO ACCESS THE SERVICE MODE
PRESS THE ON/OFF POWER KEY TO THE ON POSITION.
PRESS THE COOK TEMP, TIME AND CORE TEMP KEYS SIMULTANEOUSLY.
The service mode will appear in the display.
or
If the unit does not have a core temperature key, an additional black button is located on the back
of the display board. Remove the left-hand side of the unit or the front control panel to access it.
TO NAVIGATE IN THE SERVICE MODE
R-Number Menu
The service mode has three menus and will open in the R-Number Menu. This menu is read-only
and displays the current temperature (in Celsius), the status of all other sensors and switches, and
the most recent errors and their time of occurrence. Rotate the adjustment knob to view the
status values.
To view the last 10 errors that have occurred:
• Rotate the adjustment knob until the parameter R38 shows in the display.
• Press the up
• Press the Chef Function
it occurred.
• Press the down
• Rotate the adjustment knob to scroll to another parameter.
C-Number Menu
The second menu, the C-Number Menu, is where all sensor values are set. These values are
changeable, but should only be changed under the direction of an Alto-Shaam factory representative.
Unauthorized changes can cause damage. Rotate the adjustment knob to view these values.
D-Number Menu
The third menu, the D-Number Menu, is the diagnostic menu. Here all components can be
activated for 10 seconds at a time to aid in troubleshooting the oven. To test a component:
• Rotate the adjustment knob until the desired parameter (D07 Fan [0], D12 Oven Lamp [0], etc.)
shows in the display.
• Press the up
• Rotate the adjustment knob to change [0] to [1]. The component will activate for 10 seconds
and then the display will return to [0].
• Press the down
• Rotate the adjustment knob to scroll to another parameter.
S 3 – S
E C T I O N
L
arrow to display the last 10 errors.
key to toggle between the error description and the date and time
M
arrow to return to the parameter R38.
L
arrow to highlight the value [0].
M
arrow to return to the parameter without the value highlighted.
M E
E R V I C E O D E A N D R R O R
C • C O M B I T H E R M G A S T
O D E S
S M
E C H N I C A L E R V I C E A N U A L
• 5 8