Installation; Lifting Instructions - Alto-Shaam COMBITHERM CT PROFORMANCE CTP10-10E Installation Manual

SITE INSTALLATION
WARNING
To prevent serious injury, death, or property damage:
• Always keep appliance on top of a pallet when using a
fork lift or a pallet lift truck to move appliance.
• Always use a suff icient number of trained and
experienced workers to place the appliance on floor,
stand, or counter.

INSTALLATION

To ensure proper operation, the installation of this oven must
be completed by qualifi ed technicians in accordance with
the instructions provided in this manual. Failure to follow
the instructions provided may result in damage to the oven,
building, or cause personal injury to personnel.
NOTICE: To prevent PROPERTY DAMAGE:
Check the dimensions of the doorways and
aisles before attempting to move the oven and
pallet to the installation site.
Do not tilt the oven. Transport the oven in an
upright and level position only.
Slide the preheat strip into place before using
a forklift or pallet jack in between the trolley
guides to avoid damaging the preheat strip
when lift ing.

LIFTING INSTRUCTIONS

Remove banding before lift ing. Lift the unit from the
front only, never from the side.
Adjust the forks so that they do not damage any of the
components under the unit. Note that the control side
of the oven is the heaviest portion. Lift the unit just
high enough to remove the wooden pallet. Lower the
unit as close to the fl oor as possible and no more than
2" (50mm) above the fl oor. Secure hoses and dangling
cords to avoid tangling or damage. When moving the
unit, drive slowly, keep it low to the ground, and use
extreme caution.
MN-35947
•
Grease Collection Pump
Rev 18 05/19 Combitherm® CT PROformance™ and CT Classic Series Installation Manual
• •
DEPTH OF FORKS IS CRITICAL FOR UNITS
EQUIPPED WITH GREASE COLLECTION TO AVOID
DAMAGING THE PUMP
Installation
components
protrude below
oven
45
•