GRAUPNER mz-24 HoTT Operating Instruction page 58

• DELAY
It is used to set the time delay. The failsafe will delay for the setup time.
Touch "SET" icon to activate the value in red and adjust the value with INC and DEC buttons.
Touch "SET" icon again to deactivate the value. Touch INC button to move the cursor to "FAIL
SAFE ALL"
Touch
Touch
58
• FAIL SAFE ALL
This function allows that all failsafe position for every channel can be set at a time without the
use of F.S.POS function. Notice that MODE of all channels should be set to FAIL SAFE.
Touch "SET" icon to activate the value, NO, in red and move and hold the throttle stick to
the desired position for FAIL SAFE operation position. Touch "SET" icon then that position is
assigned to FAIL SAFE operation position and the relevant value is displayed in F.S.POS line.
The servo that is connected to receiver is operated to the set position of FAIL SAFE when
transmitter is turned off Touch INC button to move the cursor to "POSITION"
• POSITION
You may check the operation range of transmitter's stick which is connected with "INPUT CH".
Touch "ENT" icon on the right to access to the next page, "RX FREE MIXER".
Touch
Touch
Touch
Touch
Touch