Sony TRINITRON BVM-14G1A Operation And Maintenance Manual page 24

Adjusting the Color Temperature — COLOR TEMP
ADJ Menu
Overview
The color temperature is adjusted with the COLOR
TEMP ADJ menu. The color temperature can be set to
one of STD, COL1 or COL 2 for each channel.
Use the factory setting value or the adjusted value as
an original values to shorten the adjustment time.
Color temperature adjustment can be made in the
following three ways:
• Knob adjustment
Adjust the color temperature with the bias and gain
knobs manually.
• Automatic adjustment using a probe
You can use the following probes for automatic
adjustment of color temperature. Except for the Sony
BKM-14L, a cable is required to connect the color
analyzer to the monitor.
Manufacturer Probe Model Name
SONY BKM-14L (no cable required)
GRASEBY SLS 9400
MINOLTA CA-100
PHILIPS PM 5639
THOMA TF6
For more information about the cable specification required
and about the connection, see "Connection Cable
Specifications for Color Temperature Probes" on page
54.
• Copying other data
Copying data from other BVM-series monitors that
have been connected via the serial remote connector,
or from data stored in monitor memory cards.
Adjusting the Color Temperature — COLOR TEMP ADJ Menu
Structure of the COLOR TEMP ADJ Menu [B]
Level 1
MANUAL [B1]
PROBE [B2]
COPY [B3]
TRIM [B4]
2 7 2 8
Level 2 Level 3
ADJUST [B211]
SONY BKM-14L [B21] ANALYZE [B212]
GRASEBY SLS9400
MINOLTA CA-100
PHILIPS PM5639
THOMA TF6 START [B213]
X
Y
LOWLIGHT (20 IRE)
HIGHLIGHT (100IRE)
D65
D93
OTHER VALUE [B31]
STD
COL1
COL2
D65
D93
OTHER
MONITOR [B32]
MONITOR
ADDRESS [B321]
MEMORY CARD [B33] FILE NAME [B331]
ADJUST
TRIM
SIGNAL
The lower levels of GRASEBY SLS9400, MINOLTA CA-100, PHILIPS PM5639 and THOMA TF6 are the
same as [B213] in level 3 and lower than that.
Level 4 Level 5
START [B2111] SET PROBE
X ON CRT
Y
LOWLIGHT (20 IRE)
HIGHLIGHT (100IRE)
D65
D93
SET PROBE
ON THIS CRT [B2121]
SET PROBE
ON CRT
STD
COL1
COL2
STD
COL1
COL2