Sony TRINITRON BVM-14G1A Operation And Maintenance Manual page 14

Connector Panel Configuration
The unit comes standard with connectors for one
channel of Y/R–Y/B–Y or RGB. By adding optional
decoder adaptor or input expansion adaptors, the input/
output connector panel can be assembled in a wide
variety of configurations. The signals that each of the
adaptors' connectors supports are given in the table
below. The type of signal to be applied to each input/
output connector is set with the INPUT
CONFIGURATION menu.
BKM-20D BKM-21D BKM-24N
SDI 4:2:2 SDI Multi NTSC
Decoder Decoder Decoder
Adaptor Adaptor Adaptor
Serial Component ® ®
digital 525/625
input
Composite ®
NTSC
Composite ®
PAL
Analog Composite ® ®
input NTSC
Composite
®
PAL
Composite
PAL-M
Composite
SECAM
® ® ®
Y/R–Y/B–Y
525/625
®
RGB ® ®
525/625
Y/C ®
NTSC
Y/C
PAL
Y/C
PAL-M
Number of digital 3 3 –
inputs
3 3 6
Number of analog
input
* : Equipped with floating/non-floating ground mode selector for HAM reduction
Notes
The BKM-20D and BKM-21D can not provide proper
active-through outputs if a signal whose format is not
selected in the INPUT CONFIGURATION menu is
input. (If AUTO is selected, input a signal which has
the same format with the signal monitored last.)
For information about the INPUT CONFIGURATION
menu, see "Setting the Input Configuration (SET UP 1) —
INPUT CONFIGURATION Menu" on page 32.
Adaptor name
BKM-25P BKM-26M BKM-27T
BKM-28X
BKM-48X
PAL PAL-M Tri- Analog
Analog
Decoder Decoder Standard
Input
Input
Adaptor Adaptor Decoder Expansion
Expansion
Adaptor Adaptor
Adaptor
®
® ®
®
®
® ® ® ®
®
®
® ® ® ®
®
® ®
®
– – – – –
6 6 6 6 6
Overview
Note on using the BKM-20D/21D
When the input option slot on the rear of the monitor
has a BKM-20D/21D SDI Decoder Adaptor (option)
installed, if you remove and insert the analog input
connectors board, the radiation shield (see Fig. 2) of
the BKM-20D/21D may be damaged or detached.
Fig.1
Input option slot (with a cover plate)
*
Analog input connectors board
When installing the analog input connectors board
again, remove the BKM-20D/21D temporarily while
carrying out the other operations, then reinstall it.
7 8
Fig. 2
Analog input
Radiation shield
connectors board
BKM-20D/21D