Selecting the Monitor to Control — ADDRESS
Menu
Overview
When multiple monitors are connected by a serial
remote connection, the ADDRESS menu is used to
choose whether one particular monitor or monitor
group will be controlled, or whether operations are to
be performed on all monitors together.
Displaying the ADDRESS Menu
Press the ADDRESS button.
The ADDRESS button lights, and the ADDRESS
menu is displayed on the screen.
Item
Function
SINGLE
Control only a specified monitor. Enter the monitor address number.
Control only a specified monitor group. Enter the group address number.
GROUP
Control all monitors.
ALL
ALL POWER ON
Turn all connected monitors on.
ALL POWER OFF
Turn all connected monitors off.
When this item is selected, each connected monitor displays its monitor address on its
DISPLAY MONITOR ADDRESS
screen.
DISPLAY GROUP ADDRESS
When this item is selected, each connected monitor displays its group address on its screen.
SET UP PVM (BKM-103)
Transfer the INPUT CONFIG settings of a BVM monitor to a PVM monitor. The BKM-103
Serial Remote Interface Kit must be installed in the PVM monitor, and the monitor address
of the PVM monitor must be selected using the SINGLE menu item.
Notes
• To remotely control monitors connected in serial,
MONITOR ADDRESS or GROUP ADDRESS of
monitors should be correctly set in the REMOTE
menu.
For details of the REMOTE menu, see "Assigning the
Remote Control Functions (SET UP 2) – REMOTE Menu"
on page 35.
- In GROUP mode, when the KEY PROTECT
function is set to ON, the LED on the pressed
function button lights, but it is deactivated. (LED
of other monitors in the same group will not light.)
- In GROUP or ALL mode, the LEDs of the
function buttons will not light with controlled
from the menu. (LEDs light only when you press
the function button.)
By pressing the ENTER button after selecting the item,
serial remote operation becomes activated.
A D D R E S S
S I N G L E
* *
G R O U P
* *
A L L
A L L
P O W E R
O N
A L L
P O W E R
O F F
D I S P L A Y
M O N I T O R
A D D R E S S
D I S P L A Y
G R O U P
A D D R E S S
S E T U P
P V M
( B K M - 1 0 3 )
ADDRESS Menu
Settings made with the menu items are as follows:
- In GROUP or ALL mode, LEDs of controlled
monitor will light as follows.
In case of SHIFT OFF before remote control
operation: LEDs light in green when the SHIFT
button is remotely set to OFF.
In case of SHIFT ON before remote control
operation: LEDs light in orange when the SHIFT
button is remotely set to ON.
For details, see "SHIFT button" on page 12.
• In SINGLE mode, when the data is saved or load in
or from the memory card, the error message may
appear due to data communication error. In such a
case, clear the remote mode, then try again.
It is recommended to save or load data to or from the
memory card with the monitor which is free from the
remote operation.
• When Sony BVM-xxE/F and HDM-xxE series
monitors are connected together, select these
monitors for each series in SINGLE mode or GROUP
mode to remotely control them.
4 9
Selecting the Monitor to Control — ADDRESS Menu
Cancelling the Remote Control
Mode
To cancel the remote control mode, press the
ADDRESS button.
Exiting the ADDRESS Menu
To exit the ADDRESS menu, press the ADDRESS
button or the MENU button.
5 0