Sony TRINITRON BVM-14G1A Operation And Maintenance Manual page 18

Rear Panel
BVM-14G5U/14G5E/14G5A
3 Analog input/output
connectors
4 Input option slot
5 REMOTE 1 connectors
6 REMOTE 2 connector
7 ISR connector
BVM-20G1U/20G1E/20G1A/14G1U/14G1E/14G1A
3 Analog input/output
connectors
4 Input option slot
5 REMOTE 1 connectors
6 REMOTE 2 connector
7 ISR connector
8 CONTROL UNIT connector
1 MAIN POWER switch
2 AC IN connector
1 MAIN POWER switch
2 AC IN connector
(Illustration: BVM-20G1U/20G1E/20G1A)
1 5
Location and Function of Parts
1 MAIN POWER switch
When turned on, the monitor enters standby mode. By
setting in the SYSTEM CONFIGURATION menu, the
monitor can also be set to enter operation mode when
the MAIN POWER switch is turned on.
For information about the SYSTEM CONFIGURATION
menu, see "Setting Power-Up Conditions and Decoder (SET
UP 4) —SYSTEM CONFIGURATION Menu" on page 39.
2 AC IN connector (3-pin)
Connects the monitor to an AC power source, via the
supplied AC power cord.
AC power cord (supplied)
Cord stopper (supplied)
Plug holder
Attach the cord stopper to the AC power cord, and connect it
to the plug holder so that the cord does not come loose.
3 Analog input/output connectors
ANALOG
IN
Y/G connectors (BNC)
Y/G
OUT
IN
B-Y/B connectors (BNC)
B-Y/B
OUT
IN
R-Y/R R-Y/R connectors (BNC)
OUT
IN
SYNC connectors (BNC)
SYNC
OUT
RGB signals, component signals (Y/R-Y/B-Y), or
composite sync signals can be fed in the IN
connectors. The type of signal applied to each
connector is set with the INPUT CONFIGURATION
menu. The OUT connectors are used for loop-through
output of the input signal. When not using loop-
through, connect a 75-ohm terminator (not supplied) to
the OUT connectors.
1 6
For information about the INPUT CONFIGURATION
menu, see "Setting the Input Configuration (SET UP 1)—
INPUT CONFIGURATION Menu" on page 32.
4 Input option slot
One optional decoder adaptor or input expansion
adaptor can be installed into this option slot.
5 REMOTE 1 connectors (female, D-sub 9-pin)
REMOTE 1
REMOTE 1 IN connector
IN
OUT
REMOTE 1 OUT connector
These are RS-485 serial interface connectors, used for
connecting two or more BVM/HDM-series monitors.
The IN and OUT connectors form a loop-through
connection.
Connect two monitors using a cable with D-sub 9-pin
plugs such as an RCC-5G (not supplied) as shown in
the figure on the next page.