Profiles - Grandstream Networks GXW410x User Manual

SRTP Mode
Round Robin and/or
Flexible
Prefix to specify Port
(1 stage dialing method)
Dial Plan
P
ROFILES
Profiles are basically IP-PBX / SIP Server configuration templates. If you have more than one IP-PBX
system or SIP Server that you would like to use with the GXW410x, then you can configure Profile 2 or 3.
Note: Make sure you select the correct profile for each channel under Channels
Grandstream Networks, Inc.
Default is disabled for all ports. The user can select to either enable it but not force
it or force it on an individual port basis. When used the communication will be sent
using Secure RTP.
Default is rr:1-8;
The syntax is pretty straight-forward here. The rr stands for Round Robin and the
numbers stand for the ports that belong to that round robin group.
For example:
rr:1-8; -> Round robin within the first 8 ports i.e. outgoing calls will be forwarded to
the next available port within the group of ports 1 to 8.
rr:1,3-6,8;rr:2,7; -> Round robin within port 1,3,4,5,6 and 8; Second round robin
group within ports 2 and 7 i.e. outgoing calls to ports 1,3,4,5,6 and 8 will be
forwarded to the next available port within this group ONLY. Outgoing calls to port 2
and 7 will be forwarded to the next available port between ports 2 and 7 ONLY.
** In order to terminate a call on FXO port 2 or 7 you will need to change its Local
SIP Listen port accordingly.
Default is 99.
Syntax to USE this feature: prefix# (that is 99) + ch# (could be anything from 1 to 8)
+ dialing# will result in this call forwarded to FXO port (ch#) immediately.
The Dial Plan feature implemented is applicable for VOIP to PSTN calls only. You
may configure a dial plan based on the following grammar:
1. Accept Digits: 1,2,3,4,5,6,7,8,9,0,*,#,A,a,B,b,C,c,D,d
2. Grammar:
x - any digit from 0-9;
xx+ - at least 2 digit number;
xx. - at least 2 digit number;
^ - exclude;
[3-5] - any digit of 3, 4, or 5;
[147] - any digit 1, 4, or 7;
<2=011> - replace digit 2 with 011 when dialing
WARNING - illegal input will fall back to default
Example 1: {[369]11 | 1617xxxxxxx} - Allow 311, 611, 911, and any 10 digit
numbers of leading digits 1617.
Example 2: {^1900x+ | <=1617>xxxxxxx} - Block any number of leading digits
1900 and add prefix 1617 for any dialed 7 digit numbers.
Example 3: {1xxx[2-9]xxxxxx | <2=011>x+} - Allow any length of number with
leading digit 2 and 10 digit-numbers of leading digit 1 and leading exchange
number between 2 and 9;
If leading digit is 2, replace leading digit 2 with 011 before dialing
Default: PSTN Outgoing - {x+}
Note: If you do not plan to use this feature set to default {x+}
GXW410x User Manual
Firmware 1.0.1.25
PAGE
Page 23 of 33
Updated: 07/2008