‘Dmx’ Mode; ‘Slave’ Mode - Stairville LED Bar 240/8 RGB User Manual

'DMX' mode
'Slave' mode
This setting is only relevant if the unit is controlled via DMX.
Press [Mode] repeatedly until the display shows 'dxxx' . Press [Setup]. With [Up] and [Down] you
can now select one of the following DMX operating modes:
n '2-ch' (two channels)
'3-ch' (three channels)
n
'5-ch' (five channels)
n
'24ch' (twenty-five channels)
n
Wait for about 30 seconds until the display turns dark. Then the settings have been applied.
Press [Mode] to return to the parent menu without any changes.
This setting is only relevant if the unit is operated as slave device in a master / slave configura‐
tion and is not controlled via DMX.
Press [Mode] repeatedly until the display shows 'SLAv' .
Wait for about 30 seconds until the display turns dark. Then the settings have been applied.
Press [Mode] to return to the parent menu without any changes.
LED Bar 240/8 RGB
Operating
27