Wsw26 Function Setting - Brother MFC8500 Service Manual

Selector
No.
1
Not used.
2
Dialing during document reading into
3 the temporary memory in in-memory
message transmission
No. of CNG cycles to be detected
(when the line is connected via the
4
external telephone except in the
5 external TAD mode or via the built-
in telephone of the facsimile
equipment)
6
| Not used.
8
Selector 3: Dialing during document reading into the temporary memory in in-memory message
transmission
If this selector is set to "0," the equipment waits for document reading into the memory to
complete and then starts dialing. This enables the equipment to list the total number of pages in the
header of the facsimile message.
Selectors 4 and 5: No. of CNG cycles to be detected
The equipment interprets a CNG as an effective signal if it detects a CNG signal by the number of
cycles specified by these selectors in any of the following cases:
• when the line is connected via the external telephone except in the external TAD mode.
• when the line is connected via the built-in telephone of the facsimile equipment.
WSW26
(Function setting 4)
Function
29
Setting and Specifications
0: Disabled 1: Enabled
No. 4 5
0 0 : 0.5 (A)
0 1 : 1
1 0 : 1.5 (C)
1 1 : 2
WWW.OASD.CN
(B)
(D)
WWW.OASD.CN