1.20 NCU Shield and NCU PCB
(1) Remove three screws from the NCU shield, then take off the NCU shield.
Taptite, cup S M3x6
(Tightening torque: 0.5 N•m)
(2) USA version: Disconnect the main-NCU harness from the main PCB.
European version: Disconnect the main-NCU harness and main-NCU harness 2 from the main
PCB. See the illustration given on the next page.
(3) Remove the screw from the NCU PCB and take out the PCB.
IV - 48
WWW.OASD.CN
WWW.OASD.CN