Table of Contents
Advertisement
Installation and setting up
DANGER! DO NOT operate the smoke machine until you have read and
observed all the precautions listed under "Safety information" on page 3.
L o c a t i o n
The smoke machine may be located on the floor or may be suspended using
the flying bracket.
The machine can operate in any orientation from 45 degrees upwards to 45
degrees downwards. Steeper tilting may cause fluid leakage.
If the machine is to be suspended, ensure the mounting surface can support the
weight of the machine. Do not suspend the machine over areas where people
will be underneath.
Ensure that there is at least 100mm clearance all round the machine and at least
600mm in front of the smoke output.
A C p o w e r
Before using the machine, ensure that a grounding-type (earthed) power plug
that fits the local power outlets is installed on the power cable.
DANGER! Make sure the power plug is correctly rated:
• For EU (230V) use fit a plug rated 10 amp minimum
• For US (120V) use fit a plug rated 16 amp minimum
When installing the plug, follow the plug manufacturer's instructions and
connect pins as follows:
yellow and green wire to ground (earth), blue wire to neutral and brown wire to
live.
The table below shows some common pin identification schemes.
wire
brown
blue
green/yellow
Before connecting the smoke machine to power, verify that the AC supply is
adequately dimensioned for the current draw of the machine. The machine
requires:
8.21A at 230V (EU)
14.58A at 120V (US)
8
function
marking
live
"L"
neutral
"N"
earth
Installation and setting up
screw colour
yellow or brass
silver
green
Advertisement
Table of Contents
